P. Depower Main Line (KS1DEPMLE)

Contents: Depower MainLine with QR.  
     
Tools Needed: Fishing Line (2m). Small Flat Head Screwdriver. #1 Philips Head
Screwdriver (included in your kite bag).
 
1: Pass the top end of the Depower Mainline up through the centre of the IDS Control Bar. (fig 1)

2: Slide the Bungee Manager unit over the end of the Depower Main Line making sure it is the correct way round. (fig 2)

3: Slide the Recoil system over the depower mainline. (fig 3)

4: Slide the Stopper ball PU tube and stopper ball over the end of the Depower Main Line. (fig 4) Make sure the 2 screws are lined up with the Multibore tube centre partition and tighten. (fig 4)

5: Pass the CAS Lower Triangle link body through the loop on the Depower Main Line, (fig 6) and then pass the pin through one side of the shackle and through the webbing loop on the bottom of the CAS. Screw the pin tight using the small flathead screwdriver. (fig 6)

6: Pass the loop end of the Centre Line Adjuster through the upper triangle link on the CAS and create a larkshead (fig 8) and then pull through the Front Flying lines. (fig 9) Reattach the larkshead know onto the correct knot on the Centre line Adjuster.(fig 10)

7: Pass the fishing line through the IDS line loop creating a loop and then pass this down through the Depower Main line. (fig 11) Pull through the fishing line which in turn pulls the IDS line. (fig 12)

8: Reattach the IDS ring to the end of the IDS line and reset on the IDS Harness Loop. (fig 13)